Galileo - VSAT Installation Training
CHAPTER 3
Hardware Installation
DISH ASSEMBLY - Page 2 of 2
End of Section
Go back to Chapters
LNB - RECEIVER
Place a provided O-Ring into the circular groove on the LNB.
LNB - RECEIVER
Grease the O-Ring with dielectric grease. Make sure not to touch the plastic film that covers the LNB opening or the LNB will not function.
LNB - RECEIVER
Orient the LNB so that it lines up with the Waveguide Receive feed seen below.
LNB - RECEIVER
Mount the LNB with the 4 provided bolts. Be careful not to smear the dielectric grease.
LNB - RECEIVER
Tighten the LNB into place.
ROTATE RADIO UNIT
Make sure that the radio unit is held firmly in the mounting bracket, but not so firmly that you are not able to rotate it.
MOVE AND POINT
The Dish and Non-Pen mount may be moved to the permanent location.
