GROUND CONTROL
GALILEO ONLINE TRAINING

CHAPTER 2 QUIZ

 

Answers to the questions below are easily found in the chapters the questions were pulled from.  For example, Question 1 below refers to the beginning of the video, and question 10 refers to later on in the video.  It is the same for the rest of the text chapters.  I recommend that you have two web browsers open for taking these quizzes, one for the questions here, and one for the online training materials.

 

 

A TYPICAL INSTALLATION PROCEDURE

 

  1. After the customer purchases a Galileo System from Ground Control, what is the next event that happens?

 

  1. Who send the customer the Site Survey?

 

  1. Does the Installer receive a copy of the Site Survey from Ground Control?

 

  1. Prior to an installation, are there items the installer needs to purchase that are not provided by Ground Control for a successful installation?

 

  1. What is the last one thing that Ground Control needs from the installer to know that the installation is complete?

 

PREPARING THE INSTALLATION LAPTOP

 

  1. Is a copy of the online training material you are now reading included on the Installers Galileo CD-ROM?

 

  1. Are instructions included on the CD-ROM that show you how to prepare a installation laptop before you go on an installation?

 

  1. What programs do you need to install and configure on your laptop for a Galileo Installation?

 

  1. Do you need to configure Proxy settings for the laptop for commissioning a Galileo system?

 

PREPARING THE GPS RECEIVER

 

  1. Why is it important to set up your handheld GPS receiver to give you readings in decimals?

 

SITE SURVEY

 

  1. What is the purpose of the Site Survey?

 

  1. Who gives the customer the Site Survey to fill out and sign?

 

  1. According to the Site Survey, is trenching part of a standard installation?

 

  1. According to the Site Survey form the customer fills out, how much drive time is allowed in a standard Galileo Installation before the client must pay additional charges?

 

 

THE GALILEO WORK ORDER

 

  1. The Galileo Work Order is used for the commissioning of the Gateway.  Why are the dish pointing parameters section of this work order blank?

 

  1. Under what section of the Galileo Work Order can you find the login name and password to access the Gateway?

 

  1. Is a copy of the Galileo Work Order given to the customer?

 

 

TOOLS AND SUPPLIES

 

  1. To assemble the dish, the installer only needs a Socket Wrench set, a set of open end wrenches and screw drivers.  (Note, this is just to assemble the dish).

 

  1. Where can you buy Dielectric grease for the O-Rings?

 

  1. Where can you buy Concrete Bricks for the Non-Pen mount?

  2. Is it a good idea to have Coax wall plates for the installation?

 

  1. What kind of drill bit is recommended for drilling holes for cable runs?

 

  1. What is an inclinometer used for?

 

  1. Why is it important to have a cell phone on an installation?

 

  1. Is there a checklist provided on the online materials used to make sure you have all of the right tools and supplies when you go on a job?

 

  1. Can you make your own Ethernet Cables?