MAGELLAN MSS SOFTWARE (0.74m and 0.95m mobile)

Magellan MSS on-board flash updater software (always free)
Revisions: 07.16.08, 12:40pm
click here to download

TOUGHSAT MSS SOFTWARE (0.98m mobile)

Toughsat MSS on-board flash updater software (always free)
Revisions: 11.03.08, 10:33am
click here to download

Flash Updater - Instructions
Instructions for uploading software to your mobile dish
click here to download


MANUALS
Hint - to save a manual to your computer, right-click "download" and then
choose "Save Target As"

Magellan MSS Users Manual
Normal operation and instruction of use of the MSS system.
download

Magellan MSS Hardware Installation
The physical installation of the MSS on a truck/vehicle
MSS_Installation_Manual_v2 (right click and "save target as")
MSS Installation Manual_v1(older Version)

Magellan MSS System Activation
The process of activating the MSS after it has been installed so that it may
connect to the Internet or private satellite network.
download

IP Setup Utility for Windows
If you set the IP of your MSS to an unknown IP, use this utility to change it
back to 192.168.1.2
download

IP Setup Utility for Macintosh
If you set the IP of your MSS to an unknown IP, use this utility to change it
back to 192.168.1.2 ...This utility also allows you to update the MSS
software using a Macintosh.
download Instructions
download software

MSS INSTALLATION VIDEO A video demonstration of the installation of a .95 Meter Galileo MSS system. File 21 Min long and is 63 MB large. Please left click and choose "Save target As" to save on your computer. Posted October 2007 click here to download

NOTES:

If you are updating the MSS from a version older than 5-16-05, a Compass Calibrate must be done once this update is loaded.

If your MSS is working properly, follow the normal update procedure, described below.

The Hughes 6000 Modem firmware is incompatible with MSS software dated 7-27-05 and earlier.

Before the update, if your MSS page says "The page cannot be displayed" after it says "Reading Modems," follow this update procedure:

Download the update from the web. To perform this update, you will need to turn everything off. Disconnect your modem from the router. Turn on only the MSS and the router and your computer. Run update.bat. Once the update is complete, reconnect the modem and turn it on.